This order was for the installation of Stellar and HD+ into an original Xbox, a TLC service, and the replacement of the HDD for a 4TB SSD, as well as the motherboard, PSU and DVD drive recap and a 128MB RAM upgrade. The console as pre-modded with a softmod and in relatively good condition, although […]
This order was for the TLC of a phat white Xbox 360, a slim black Xbox 360, and a phat PS2. The consoles were dirty but overall in good condition. The PS2 however didn’t recognise any discs, and the white xbox 360 got damaged in transit. White Xbox 360 The console had a lot of
This order was for a package service for an original xbox, with TLC, modchip installation, 1TB new HDD installation, but with a full recap service. The console was in good condition but unfortunately arrived damaged from shipping. This was probably a combination of somewhat brittle plastic and the console not being packaged with sufficient padding
This order was for the installation of a Retro GEM in a white Nintendo Wii. The console was in good condition with no operational problems. The console was first disassembled and the capacitors replaced. After that, the support for the Retro GEM board was installed, and then the flex around the AVE chip was soldered
This order was for the TLC of both an indigo Game Cube and a black phat PS2. Customer advised that the shell of the Game Cube didn’t need washing as they were going to be replaced anyway. So the TLC serviced focused on dusting, replacing the thermal pads, cleaning the fame and retrobrighting the front
This order was for the recap and TLC for an original PC Engine, and the recap of a Super CD-ROM 2. Customer reported the Super CD-ROM 2 to read CDs very slowly. First the PC Engine. The console worked fine as tested with RGB through an adapter on the expansion port. The recap was straight
This order was for the TLC and retrobrighthing of a japanese Super Famicom. Initially the customer sent the console for a repair, as it wasn’t booting. However on arrival, the console tested fine with a Triad power supply, while the power supply provided by the customer did not work (and not provide any output power).
This service was for the full recap of a GameCube, a TLC refurb, and the installation of a PicoLoaders with an SD2SP2. The customers provided the SD card, which was configured to work with the PicoLoader, and provided a GameBoy adapter to test that the SD card can be accessed from the side of the
This order was for a set of mods and work on a PS2 fat model 39003: For this model of the PS2, the Retro GEM installation requires a 5000x PSU and shield as the one that comes with the console cannot accommodate the GEM’s PCB otherwise. I sourced a 50004 console and removed the PSU,
The service was for the refurbishment and TLC of a black PS2. The console was somewhat dirty but not in too bad condition. The warranty sticker was still intact. First the console was dusted with an air blower, and then the plastic shell washed with soap and water. Battery was replaced and the thermal pads
